ENGLISH
Instruction manual ELEKTRONIKA PROFI
21
4 MACHINE INSTALLATION
The installation is to be carried out exclusively by qualified staff and according to the following
instructions and in compliance with valid laws.
The following chapters deal with the preparation of the machine, its electricalconnection, water supply connection
and drain connection. Please note that for water tank machines, only the subchapters “Preparation of the machine”
and “Electrical connection” are relevant.
4.1 Preparation for the installation
Place the machine on an even and stable surface. You can regulate the height of the machine by
adjusting the feet of the machine.
Never place the machine on hot surfaces.
4.2 Electrical connection
Make sure that the local main supply voltage corresponds to the information given on the type
plate on the front panel of the espresso machine.
Plug the machine only into an earthed socket and do not leave it unattended.
Do not roll or bend the power cord.
Do not use an extension cord/ do not use a multiple socket.
4.3 Water supply connection
Important!
Make sure that the water supply installation is connected to potable water supply with an operating
pressure ranging from 0 to 3 bar. In case of an operating pressure of more than 3 bar use a pressure
regulator.
Please note that often the pressure of the water supply varies. If the water supply pressure temporarily
exceeds 3 bar, use a pressure regulator.
Connect the water connecting hose of the machine to the water supply valve and bolt them together.
Important!
The connection of the machine to the water supply and the installation of the pressure regulator is
to be carried out by expert staff.
To avoid an early calcification of the machine we recommend to use a water softener/ water filter.
Conventional water softener/ water filter can be purchased at your specialised dealer. However,
please note that even when using a water softener/ water filter the machine needs to be descaled
regularly.
4.4 Drain connection
By default, also in machines with water connection the user can dispose of the excessive water by regularly emptying
the drip tray.
However, it is possible to belatedly install a direct connection to the drain system. Therefore, find a fitting and a
drain hose in the product delivery.
Important!
In case you should go for a direct connection of the machine to the drain system, a hole has to be
drilled in the drip tray. This work can be carried out by expert specialised staff or by ECM
Manufacture service.
(69 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern